The relatively small back light does not actually show the actual width of a BMW, especially when side cases are attached.

This tailor-made 3M film kit reflects the light shining on it which increases the signaling effect considerably. The actual width is immediately visible and the vehicle can be seen from a distance, increasing passive safety enormously. Simple to apply. Made-to-measure for Original BMW cases. The reflective material is black, and thus nearly invisible in daylight. At night however, lights from vehicles behind you brightly reflect. See the images under the More Views tab.

Kit contains enough material for both bags. Clean the bag lids, peel and stick.

Fits the bags of the 2006 on K1200GT, K1300GT, R1200R/RT/ST

Rebuilt ignition sensor for all R850R,1100R/RS/RT/GS and R1150R/RT up to 2002. These units are rebuilt with stronger wiring and connector than stock. BMW p/n 12 11 2 306 137

This part has long been discussed in Internet forums and has received much praise. They subtly close up the gap between fairing and cylinder, effectively preventing turbulences that occur underneath the fairing (one of the main problems with all GS). A more than incredible effect, which provides the best wind protection we have ever tested, especially combined with the “ERGO” touring screens. The GS and Adventure are given the wind protection system of a super-tourer without being conspicuous. The sophisticated design of the shape effectively protects the knee from wind and weather. Even long tours become a pleasure. Made of 6.5 mm strong, scratch and shatter-proof acrylic plastic. With TÜV approval and all the necessary attachment parts. Can be used with or without engine protection bars.

Comes with installation kit

Fits R100GS

The unique MultiPod holder system allows adjustment down to the last millimetre in any direction. It is also pre-configured as a versatile holder for cameras, etc.

The set contains the Wunderlich device case and a matching MultiPod fixing system that can be attached to a holder clamp.

Consisting of: one aluminum MultiPod 360, one plastic device case (to be used with the origianl vehicle connection cable) and a model-specific installation kit.